LED AUXILIARY LIGHT
Most accidents occur because motorcyclists overlook you. Additional headlights are increasingly being mounted on motorcycles in order to be seen better or to see better even in the dark. With the LED auxiliary headlights, HEPCO & BECKER has the optimal solution - with an E-mark, of course.
Nova LED additional headlight set incl. universal attachment
£268.40*
With the Nova LED additional headlight set from HEPCO&BECKER you get everything you need to improve the visibility and safety of your motorcycle. This set contains powerful LED additional headlights, a universal mounting set, a cable set, a switch, instructions and a tool set to conveniently mount and control the headlights. The Nova LED additional headlights not only offer improved illumination of the road, but also give your motorcycle an attractive look. Easy installation is made possible by the included universal mounting set and cable set. Increase your safety and add an attractive design to your motorcycle by using the HEPCO&BECKER LED additional headlight set Nova.
High-power LEDs with two switching levels at 2,500lm - 4,350K / - 5,500K12 volts, per headlight 25 watts
ECE tested and approved, therefore no individual approval is required (observe country-specific legal regulations for installation)
Improved traffic light conditions
Universal attachment to engine or tank protection bar with tube Ø18mm – Ø25mm, can be attached standing or hanging
Complete headlight set; Incl. 2x LED additional headlights, 1x switch, 1x cable set, 2x clamp incl. reducing sleeves, 1x instructions, 1x tool set
Connection is only via the battery, no connection to the vehicle wiring harness is required
No external operation by third parties, thanks to a special control unit with automatic voltage controlWaterproof and dustproof to IP67Headlights can be flexibly switched on using the switch on the handlebarsNote:
The lights can only be switched on approx. 5-15 seconds after the engine has been started. A
voltage of 13.1 V must be applied to the control unit of the wiring harness to enable the circuit.
In older vehicles, this can be achieved by briefly increasing the engine speed.
Switching off must be done manually using the switch. The NOVA LEDs continue to light up until
the voltage limit of 11.8 V is reached, even after the engine is switched off. Only when the voltage
falls below this limit do the lights switch off automatically via the control unit. When switching
on again (wait for the time limit of control unit), the voltage limit of 13.1 V is queried again.
Headlight clamp (M4 thread) for LED Nova headlights (one piece)
£17.35*
only suitable for additional headlights with M4 thread, please check before orderingSpare part for LED Nova additional headlights1x Headlight clamp including screws and toothed washer